Note
Access to this page requires authorization. You can try signing in or changing directories.
Access to this page requires authorization. You can try changing directories.
This message is sent by the host to terminate the network connection.
REMOTE_NDIS_HALT_MSG(UINT32)NdisMessageType;(UINT32)MessageLength;(RNDIS_REQUEST_ID)RequestId;
Parameters
- NdisMessageType
Specifies the RNDIS message type, which is set to REMOTE_NDIS_HALT_MSG. - MessageLength
Specifies the total length of this RNDIS message in bytes. - RequestId
Specifies the Remote NDIS message identifier value. This value is used to match device responses to host sent messages.
Return Values
None.
Remarks
Implementation of REMOTE_NDIS_HALT_MSG is optional. If implemented, the device sends this message to the host through the control channel only when the device is in the rndis-initialized or rndis-data-initialized state. The device must terminate all communication immediately after sending this message. Sending this message causes the device to enter the rndis-uninitialized state.
Unlike the other host initiated control messages, there is no device response to REMOTE_NDIS_HALT_MSG. The message may be sent at any time that the device is in the rndis-initialized or rndis-data-initialized state. For more information about RNDIS device states, see RNDIS Concepts.
Requirements
OS Versions: Windows CE .NET 4.0 and later.
Header: Rndis.h.
See Also
RNDIS Concepts | REMOTE_NDIS_INITIALIZE_MSG | RNDIS_REQUEST_ID
Send Feedback on this topic to the authors